The BLA Outboard Motor Support Block is a simple and effective way to support your outboard motor while your boat is being transported on the trailer. Designed to fit over the single trim/tilt ram, it supports the engine in a raised position and helps reduce unnecessary load and movement through the hydraulic trim system while towing.

Manufactured from hard polyurethane, the block is tough enough for regular marine use while remaining quick and easy to fit before travelling and remove when you arrive at the boat ramp.

Helps Protect Your Outboard During Towing

When an outboard is tilted up for road transport, its weight can place additional loads through the trim and tilt system as the boat travels over bumps and uneven roads.

The BLA support block fits around the trim/tilt ram and allows the engine to be lowered gently onto the block, providing additional physical support while the boat is being transported.

Designed for Single-Ram Trim & Tilt Systems

The support block is designed for single-ram hydraulic trim and tilt systems with a 19mm ram shaft.

Its quick-fit design allows it to be installed in seconds without complicated brackets or tools.

Simply raise the outboard, position the support block over the appropriate trim/tilt ram and carefully lower the engine until it is supported by the block.

Suits a Wide Range of Outboards

The support block is designed to suit many single-tilt outboards from approximately 50hp to 300hp, provided the engine uses a compatible 19mm trim/tilt ram arrangement.

Because trim and tilt configurations vary between engines, compatibility should always be checked against your particular outboard before use.

Hard Polyurethane Construction

The block is manufactured from durable hard polyurethane, providing a resilient support surface suited to the marine and trailering environment.

The block can also be cut shorter where required to better suit a particular installation.

High-Visibility Red

The bright red finish makes the support block easy to see when installed.

This also provides a useful visual reminder that the support block is fitted and needs to be removed before operating or lowering the outboard for launching.

Features

• Supports an outboard motor during road transport
• Helps reduce load on the hydraulic trim and tilt system
• Helps minimise unwanted motor movement while towing
• Designed for single-ram trim and tilt systems
• Suits a 19mm trim/tilt ram
• Suitable for many 50–300hp outboards
• Hard polyurethane construction
• Quick and easy to install
• Quick to remove before launching
• Can be cut shorter to suit some installations
• High-visibility red finish
• Compact and easy to store aboard the boat or in the tow vehicle
• Suitable for many popular outboard brands